fitting a torque converter belt

Status
Not open for further replies.

robbie

New member
Messages
857
Reaction score
9
Location
Osceola, Missouri
This is my first time using a Comet torque converter, and I have a few questions. I got a Manco Dingo kart last week, and the driver was severely bent, so I ordered a new one, and a belt. I haven't received the driver yet, but I got the belt yesterday.

I put the belt on the driven pulley, and the belt barely reaches the engine crankshaft. At rest, the driven pulley is narrow enough that it causes the belt to be out on the edge. Is this normal?

I followed the chart on this website when I ordered the belt: http://www.gokartsupply.com/tcbelts.htm. The shaft centers are between 6.75 and 7 inches apart, and the inside width of the driven pulley is 3/4". According to the chart I got the right belt, but it just seems so short.

Is there an adjustment that needs to be made on the driven pulley?
 

robbie

New member
Messages
857
Reaction score
9
Location
Osceola, Missouri
Here's a photo of the belt. Isn't the belt supposed to be loose at idle? I have a hard time imagining that this will be able to have any slack in it. When I receive the driver pulley in the mail, am I going to find that it has a small enough diameter in the middle to make the belt fit just right?
 

Attachments

  • DSCN8855.JPG
    DSCN8855.JPG
    145.7 KB · Views: 18

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
That belt looks fine, you can push the belt further into the driven if you want, but it will adjust itself automatically the first time you rev the engine.
 
Status
Not open for further replies.
Top