robbie
New member
This is my first time using a Comet torque converter, and I have a few questions. I got a Manco Dingo kart last week, and the driver was severely bent, so I ordered a new one, and a belt. I haven't received the driver yet, but I got the belt yesterday.
I put the belt on the driven pulley, and the belt barely reaches the engine crankshaft. At rest, the driven pulley is narrow enough that it causes the belt to be out on the edge. Is this normal?
I followed the chart on this website when I ordered the belt: http://www.gokartsupply.com/tcbelts.htm. The shaft centers are between 6.75 and 7 inches apart, and the inside width of the driven pulley is 3/4". According to the chart I got the right belt, but it just seems so short.
Is there an adjustment that needs to be made on the driven pulley?
I put the belt on the driven pulley, and the belt barely reaches the engine crankshaft. At rest, the driven pulley is narrow enough that it causes the belt to be out on the edge. Is this normal?
I followed the chart on this website when I ordered the belt: http://www.gokartsupply.com/tcbelts.htm. The shaft centers are between 6.75 and 7 inches apart, and the inside width of the driven pulley is 3/4". According to the chart I got the right belt, but it just seems so short.
Is there an adjustment that needs to be made on the driven pulley?