Engine spluttering

Status
Not open for further replies.

Nodroz

New member
Messages
1,071
Reaction score
10
Location
Belgium (Europe)
Hello guys,

I bought a used Kohler K181 8hp engine 3 months ago. The engine didn't run, as the seller said us. I cleaned the clogged fuel lines and carburetor. After some time I got the engine running.

Since then, I barely used the engine. A few weeks ago I mounted it on my gokart and fired it up. When I want to accelerate the engine start spluttering. I doesn't even have power to get my started. I thought there might be a bad connection cable to the ignition coil. I replaced that cable, because I've seen that cable was damaged.

Even when I replaced that cable, it still splutters and doesn't want to take off. After that, I thought the carb needs another cleaning. Today, I did that, but still the same result.

Spark plug has been changed and fresh oil added.

I think that the ignition coil could be broken, or maybe there is somewhere a bad contact in my circuit. Do you guys have some ideas, suggestion to help to fix this problem?

Regards,
Nodroz
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
lets not jump into that yet. First, it it an adjustable carb? may just be out of adjustment. the wrong adjustment will cause that. next is the float or needle stuck? im sure if youve cleaned the carb you know how to check. and last did you take a small wire and push them through the idle/high speed jets and make sure they had no debris in them?
 

Nodroz

New member
Messages
1,071
Reaction score
10
Location
Belgium (Europe)
lets not jump into that yet. First, it it an adjustable carb? may just be out of adjustment. the wrong adjustment will cause that. next is the float or needle stuck? im sure if youve cleaned the carb you know how to check. and last did you take a small wire and push them through the idle/high speed jets and make sure they had no debris in them?

Thanks for your answer. I'll try to answer you question as good as possible.

It is an adjustable carb, with 3 screws - the main screw, the idle screw and I guess the high speed screw. I'm not experienced with adjusting carburetors at the moment. I'll try to search some more information on the internet or even go to the local shop, so they might do that for me.

I've checked the floater and the needle and they both seem to be fine.
I haven't done that last yet. I'll try all of this and get back to you soon. Thanks!
 
Status
Not open for further replies.
Top