Engine mods

Status
Not open for further replies.

Lawes12

New member
Messages
18
Reaction score
0
What does everyone think of this set up a LCT 291 cc with govenor removed main carb jet increased to 90, less restrictive intake and exhaust. Do you guys think I need to switch out valve springs to 18 lbs because I removed govenor or no?
 

Jrgunn5150

Rudderless
Messages
1,028
Reaction score
12
What does everyone think of this set up a LCT 291 cc with govenor removed main carb jet increased to 90, less restrictive intake and exhaust. Do you guys think I need to switch out valve springs to 18 lbs because I removed govenor or no?

If you remove the governor, the stock valvesprings allowing the valves to bounce, or float, will be your rev limiter. If you upgrade valvesprings, then you'll be able to rev high enough to toss a rod or explode a flywheel.

But the basic mods you listed have made my Predator very snappy.
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
I have answered this in your other thread

You do not have to upgrade anything internal if the governor is removed. The stock springs will cause the valves to float at about 5000rpm's, so the engine will not cause any failures. As soon as you want to upgrade the springs to say 18lbs or higher, then you will need to get a billet rod to avoid potential engine failure
 
Status
Not open for further replies.
Top