Matman24
Rabid Cat Tamer
Hello everyone! I'm planning on putting together an electric conversion for a go kart, and I'm in dire need of some advice.
This project is probably gonna be built on a basic kart chassis (depending on what u can find used), and I'm planning on using it on tarmac, gravel and probably some dirt trails, but no serious off-roading. It would be a decently powerful little cart, probably around 6-7kW or so.
I just need help in regards to the sizing and proper selection of my major components. Also, I'd like to keep total costs for these components below 1000-1200$ if possible.
For my motor, I was looking into probably a Motenergy ME0909 Brush-type DC motor. http://www.motenergy.com/me0909.html
For my controller, I was wondering about anyone's experience with Kelly Controllers, since they seem like quite the deal.
http://kellycontroller.com/kdz4820124v-48v200apm-with-regen-p-952.html
Lastly, for batteries I honestly have no clue. I was considering maybe using a bunch of LiPo batteries like these:
https://hobbyking.com/en_us/turnigy-5000mah-4s1p-14-8v-20c-hardcase-pack.html
But, I would need a ton of them to get it to last more than 15mins, so any suggestions would be greatly appreciated!
This project is probably gonna be built on a basic kart chassis (depending on what u can find used), and I'm planning on using it on tarmac, gravel and probably some dirt trails, but no serious off-roading. It would be a decently powerful little cart, probably around 6-7kW or so.
I just need help in regards to the sizing and proper selection of my major components. Also, I'd like to keep total costs for these components below 1000-1200$ if possible.
For my motor, I was looking into probably a Motenergy ME0909 Brush-type DC motor. http://www.motenergy.com/me0909.html
For my controller, I was wondering about anyone's experience with Kelly Controllers, since they seem like quite the deal.
http://kellycontroller.com/kdz4820124v-48v200apm-with-regen-p-952.html
Lastly, for batteries I honestly have no clue. I was considering maybe using a bunch of LiPo batteries like these:
https://hobbyking.com/en_us/turnigy-5000mah-4s1p-14-8v-20c-hardcase-pack.html
But, I would need a ton of them to get it to last more than 15mins, so any suggestions would be greatly appreciated!