Easy way to reverse engine direction

Status
Not open for further replies.

ghostdog

New member
Messages
139
Reaction score
0
Does anyone know if there is some sort of sprocket that can reverse the direction another sprocket is turning?

The way I am fitting my engine is with the shaft on the right side instead of the left side. This basically moves the cart in reverse if hooked up normally.

My worst case solution involves idler sprockets that will change the direction of the chain to go past the bottom of the axle sprocket to reverse the direction.

This picture illustrates what I am referring to.

The ideal solution would be some sort of sprocket that has a opposite rotating sprocket attached to it. I am not sure if something like that exists.

Please keep in mind my axle will not have a 10 tooth sprocket. It's just for illustration purposes.

Let me know your thoughts guys.

 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
More importantly, why is all this necessary? Your idea could work, but is bulky, costly, complex, and adds to horsepower-robbing friction and rotating mass. Perhaps there's another solution that would allow you to skirt this issue more cleanly?
 

ghostdog

New member
Messages
139
Reaction score
0
The cart I am recovering does not have a live axle. The location to mount the axle sprocket is on the far right side. I would need a jackshaft that is really long, almost like another axle to to reach all the way to the other side.

The brakes / bracketry are already in place on the far right side so I couldn't just flip it.

Two options were to flip the axle and redo the brakes or reverse the direction and keep the brakes intact.

So the solution I had in mind was to put the engine shaft towards the middle of the kart to keep the distance to connect the two as short as possible.
 

the-cyborg

New member
Messages
476
Reaction score
6
Location
Spring, Texas
Many early vintage karts had dead axles and engines on the right rear, and/or both sides. as the first karts literally used 2 cycle chainsaw engines.
In the late 50's early 60's such manufactures as McCullough, West Bend, Homelite, Power Products to name a few started making specialized kart engines based on their chainsaw engine counterparts, with what would be called right hand CW pto end and left hand CCW pto end engines, that helped kick start a whole new craze in karting of multiple engines.

Now if this is the case and you have an early vintage kart, I beg you please don't deface a piece of karting history trying to reinventing the wheel "literally" try and go with more of a period correct setup. If for need help or or input please PM me, I'll share every thing I know with you, and if I can't answer your questions, I'll refer you to people that can.
 

ghostdog

New member
Messages
139
Reaction score
0
it is a Chinese buggy , only thing vintage is the rust it had. Originally had a gy6. Don't cringe guys.
 
Status
Not open for further replies.
Top