Hello every one, this is my first time posting.
I would like to start off by saying this forum has been very helpful for our build.
We are building a supermilage car for shell eco marathon that is based off a go kart, for example the entire steering system and drive train.
Our engine is a 4.6 hp hatz 1b20 diesel, with a 3/4 shaft. So its very similar to other gas engines.
However, i am looking at this from a fuel efficiency standpoint.
we are planning on using a jackshaft because we have one rear wheel ( 3 wheels on the car) and the sprocket on the hub is on the right side. So that is major power loss. I was wondering if a direct drive would be feasible rather than a clutch. We are staying at 2500 rpms as that is most torque and least fuel consumption, Our goal is using as low amount of fuel as possible, speed does not matter. So staying at that rpm I am worried that it might burn out the clutch. the engine comes with electric start so we can start it right up and for the majority of the time the engine is going to be turned off. In addition I was thinking that a direct drive would have least power loss ans there is no friction and slippage.
Would we just add a 3/4 keyed sprocket with shaft collars on the side to the output shaft?
The wheel hub has a clutch like any other bicycle would. so we shouldn't have any problems with engine strain.
Its also a very light frame made of carbon fiber.
I want to hear peoples thoughts on this, and if direct drive would be the best idea. Feel free to ask any questions.

I would like to start off by saying this forum has been very helpful for our build.
We are building a supermilage car for shell eco marathon that is based off a go kart, for example the entire steering system and drive train.
Our engine is a 4.6 hp hatz 1b20 diesel, with a 3/4 shaft. So its very similar to other gas engines.
However, i am looking at this from a fuel efficiency standpoint.
we are planning on using a jackshaft because we have one rear wheel ( 3 wheels on the car) and the sprocket on the hub is on the right side. So that is major power loss. I was wondering if a direct drive would be feasible rather than a clutch. We are staying at 2500 rpms as that is most torque and least fuel consumption, Our goal is using as low amount of fuel as possible, speed does not matter. So staying at that rpm I am worried that it might burn out the clutch. the engine comes with electric start so we can start it right up and for the majority of the time the engine is going to be turned off. In addition I was thinking that a direct drive would have least power loss ans there is no friction and slippage.
Would we just add a 3/4 keyed sprocket with shaft collars on the side to the output shaft?
The wheel hub has a clutch like any other bicycle would. so we shouldn't have any problems with engine strain.
Its also a very light frame made of carbon fiber.
I want to hear peoples thoughts on this, and if direct drive would be the best idea. Feel free to ask any questions.
