Dingo w/ harbor Freights 7 hp - Belt Alignment Question

Status
Not open for further replies.

Dosher

New member
Messages
11
Reaction score
0
Location
mississippi
I posted a new thread that is a two seater i pickup for a father son build that has a clutch system that looks like the one you have any help would be great the motor wasn't on it fresh out the woods.
 

GTPAddict

New member
Messages
11
Reaction score
0
I'll double check when I get home tonight, but I believe it has about 1/2" of slack now. Still thinking the belt is too long/worn out. I can easily make the belt face touch between the pulleys for at least 2-3 inches I'm going to measure the shaft distances and make sure I'm still OK for a stock length belt. I found a site (http://www.gokartsupply.com/tcbelts.htm) with belt/pulley/shaft measurements that I was going to go by.

Dosher - Looks good man! I would have prefered this one to have been a 2 seater, but this is what I found and my boy is happy so far! Here's a link to our progress... http://www.theblattners.com/GoKart/default.html

I'll let y'all know what I find on the belt.
 

GTPAddict

New member
Messages
11
Reaction score
0
Got home and checked the chain slack and it was just about a 1/2 inch. The thing I didn't notice when I replaced the chain was how worn the jackshaft gear was. Today was the first time I'd had time to actually look at the thing in the light. I rode it a bit and noticed it was slipping on the chain. I took the chain off and the jackshaft sprocket is just worn out. Attached is a pic. I ordered another from gokartsupply.com (little bugger was kinda hard to find), hopefully it will be here by next weekend.

Thanks again for all the help. I'll post up and let y'all know how everything works with the new sprocket.
 

Attachments

  • IMG_0919.jpg
    IMG_0919.jpg
    53.8 KB · Views: 4
Status
Not open for further replies.
Top