well its kinda too late cause we had to cut up a piece to get it off the engine shaft.... i dont get what was making it stick like that. even with enourmous force it didnt budge.
got the nut off the jackshaft.
oh and blaz, this is the TC that the user homemadegokarts1221 was talking to you about.
EDIT: oops meant the driver has a piece cut up. my bad.
my bad..... the driver is screwed thats why i bought a new one.. and now i need to exchange... the driven is fine, im just going to clean it up a little.
The hub not sliding through is a CLEANING issue man. We see that all the time. Yes, series 20/40/88/maxtorque are symmetrical, series 30/99 are a-symmetrical. The 20 on the driven clutch does not have anything to do with the series either.
Keep the bushing dry, you can spray it with graphite. We clean it off with a sort of thinner, but always wear safety glasses, gloves, etc with dealing with that stuff. Stay well ventilated... I can't remember if you're the one that does go-kart work in a basement but don't use gas or carb cleaner in a basement.