Deep Six the TC (?)

Status
Not open for further replies.

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
47
Location
Houston, Texas
Where are you getting the 16" number on your tires? Your kart has 18" tall tires in the pictures you posted.

Also for 16" tall tires on the rear of a kart you effectively would need a 72T sprocket. I'm also going to have to question your estimated speed of 30mph or why you would think a yerf-dog could reach 40 under normal circumstances with a torque converter.
 

spyder1968

New member
Messages
285
Reaction score
1
Location
New Bedford, MA
if you are not off roading with it then maybe consider smaller diameter tires if going the cent. clutch route? otherwise, as already stated, i am betting you will not be happy with that setup ( engine size, gearing and tire size) reguardless of which cent clutch you try.
just my .02 cents
 

Iron John

New member
Messages
397
Reaction score
26
Location
NA
Where are you getting the 16" number on your tires? Your kart has 18" tall tires in the pictures you posted.

Also for 16" tall tires on the rear of a kart you effectively would need a 72T sprocket. I'm also going to have to question your estimated speed of 30mph or why you would think a yerf-dog could reach 40 under normal circumstances with a torque converter.

The 18's are going to be replaced with 16's when I swap axles. I got a set of 5 16's from BMI for cheap.

When we bought the Yerf-Dog, it came with paperwork that said it would do 40 to 45. It was pretty quick out of the box. That was 15 years ago; no GPS phones back then. :)

As far as now, based on who and how the cart gets used, 20 would be plenty.
 

Iron John

New member
Messages
397
Reaction score
26
Location
NA
if you are not off roading with it then maybe consider smaller diameter tires if going the cent. clutch route? otherwise, as already stated, i am betting you will not be happy with that setup ( engine size, gearing and tire size) reguardless of which cent clutch you try.
just my .02 cents

The tires will be 16". If the 60 tooth sprocket will still be too tall, I could go to a 72 or larger (if that provides enough ground clearance) or I could keep the jackshat (what overall ratio should I target in that eventuality?). Again, 20 mph target.
 
Status
Not open for further replies.
Top