Crankshaft milling?

Status
Not open for further replies.

stocked

New member
Messages
1
Reaction score
0
I have a 10hp Techumseh, Its old and ugly but runs great besides missing a muffler and the float in the carb sticking... BUT the previous owners ground the original 1" crank down to accept a 3/4 Clutch, and did a horrible job of it might i add, instead of having a key way to hold it they just drilled 2 holes in the clutch and tapped them adding 2 screws to tighten and hold the clutch to the crank. I have a good 5/8"s Clutch that is just laying around.. Could i just have a local machine shop mill it down to 5/8s for me or would that be a bad idea? I'm a complete newb to karts btw and any help would be appreciated.
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
Very slight possibility (imperceptible?) of twisting given the hp.
Knowing what I know...if I had no other choice, I would go for it.
PTO is n/g to begin with. Most that can be lost is the cost of grinding.
 

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA
Does the end of that crank have a 3/8' threaded hole? If so, it seems we'd be getting pretty thin turned down to 5/8", and then after you figure in the keyway... Does that clutch use a 3/16" key?

Another possible hitch I was considering here is if that 5/8" bore clutch was for a 2 stroke and had a lock-up rpm higher than your Tecumseh turns.
 
Status
Not open for further replies.
Top