I have a 10hp Techumseh, Its old and ugly but runs great besides missing a muffler and the float in the carb sticking... BUT the previous owners ground the original 1" crank down to accept a 3/4 Clutch, and did a horrible job of it might i add, instead of having a key way to hold it they just drilled 2 holes in the clutch and tapped them adding 2 screws to tighten and hold the clutch to the crank. I have a good 5/8"s Clutch that is just laying around.. Could i just have a local machine shop mill it down to 5/8s for me or would that be a bad idea? I'm a complete newb to karts btw and any help would be appreciated.