I have a Manco Go-Kart with a 5 hp Tecumseh OHH50 recoil engine. Mounting bolt pattern is 3-1/8 by 6-3/8 (OC's). I want to replace this engine with an electric start engine, such as a 7 HP Duromax, to make it easier on my young grandsons to use the kart. I've learned the Duromax bolt pattern is 3-3/4 by 7-3/4 (OC's).
Here are a few initial questions I have:
1. I have enough metal on the existing mounting mounting plate to redrill new holes to accept a new engine, but I was wondering if there are any other electric start engines with same bolt pattern as the OHH50. My searches all come up with Durmax engines. Does anyone have any recos? Are there any off the shelf adapters I could purchase to connect a Duromax to the existing mounting plate?
2. Do these electric start engines require an external battery? There is very little technical information on the internet about these engines.
3. The OHH50 has a 3/4 shaft. Are key way widths standard? That is, does every 3/4 engine have the same key width? If not, are there clutches made for the different widths?
Thanks everyone
Bob
Here are a few initial questions I have:
1. I have enough metal on the existing mounting mounting plate to redrill new holes to accept a new engine, but I was wondering if there are any other electric start engines with same bolt pattern as the OHH50. My searches all come up with Durmax engines. Does anyone have any recos? Are there any off the shelf adapters I could purchase to connect a Duromax to the existing mounting plate?
2. Do these electric start engines require an external battery? There is very little technical information on the internet about these engines.
3. The OHH50 has a 3/4 shaft. Are key way widths standard? That is, does every 3/4 engine have the same key width? If not, are there clutches made for the different widths?
Thanks everyone
Bob

