How close does the primary and secondary sheaves have to be aligned to avoid belt issues????
They are parallel to each other because I’m using a backing plate so there is no issue there.
And I’m trying to run an outboard secondary so the pulleys are aligned better,
But there is still quite a bit of offset between them.
Can you shim between the primary and the crankshaft shoulder to get better alignment???
The comet magnum 44 primary instructions say the clutch must be against the crank shoulder…….
They are parallel to each other because I’m using a backing plate so there is no issue there.
And I’m trying to run an outboard secondary so the pulleys are aligned better,
But there is still quite a bit of offset between them.
Can you shim between the primary and the crankshaft shoulder to get better alignment???
The comet magnum 44 primary instructions say the clutch must be against the crank shoulder…….