StudNut
New member
I am almost finished with a little project for my son and would like some advice on gearing it properly. My son is fascinated with Hummers...so I built him one out of wood (as a soap box derby car). When he turned 8, I decided to put a motor under it (I stole it from an old Sears lawn edger). I am not sure of the size of the motor, guessing around a 2hp Tecumseh with a 1/2 shaft. I have an 11 tooth clutch and the sprocket on the live axle has 50 teeth. The rear tires have a circumference of around 33" and the diameter of the tire is around 10". The kart will putt around with him on it (slowly) and if I try to ride it, it won't budge without a push start. I'm not sure of the motors rpm - I a short video of him riding it with full throttle below http://www.youtube.com/watch?v=08erAPAPJOU The kart is pretty heavy (about 100-125 lbs) and I would be another 200 lbs if I were to ride it. I tried to fit a 3.5 B&S motor under it but there is not enough room in the engine compartment....that's why I went with the smaller motor. Any advice would be appreciated

