clutch question

Status
Not open for further replies.

japandrags

New member
Messages
1
Reaction score
0
hi guys im new here , and i just bought a go kart for project but i think i have missing some parts and need to know what to do , and what clutch do i need , any help i will apreciate thanks!!!




 

Jake.B

New member
Messages
495
Reaction score
0
Location
California-USA
I had 5 horse B&s with a to short pto. I went and bought a half inch drive 13mm socket and used a section of that as a bushing. So i cut it to lenght( use a chop saw they are hardend steel) Then put the clutch on, and bolted it down it worked great.


P.S i had to grind a flat spot on the socket so the key would slide over it , pretty simple task just bring your clutch along, and mesure your pto thickness. My shaft was 3/4 an inch and therefore that socket worked but if yours is a different size just bring your clutch to a hardware store that sells individual sockets and test some and figure the one with the least play.

Also my clutch was a hillard extreme duty, so im not sure if this idea is compatible with all clutches
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I had 5 horse B&s with a to short pto. I went and bought a half inch drive 13mm socket and used a section of that as a bushing. So i cut it to lenght( use a chop saw they are hardend steel) Then put the clutch on, and bolted it down it worked great.


P.S i had to grind a flat spot on the socket so the key would slide over it , pretty simple task just bring your clutch along, and mesure your pto thickness. My shaft was 3/4 an inch and therefore that socket worked but if yours is a different size just bring your clutch to a hardware store that sells individual sockets and test some and figure the one with the least play.

Also my clutch was a hillard extreme duty, so im not sure if this idea is compatible with all clutches

If I'm reading this right, the problem is as follows: While that chunk 'o' socket is taking up space inside the clutch and it "looks" like it fits okay, only the PTO shaft is actually driving the clutch. The socket is not transferring any torque. I can see a real potential for shaft damage here, depending on how much shaft-clutch contact there is (or is not).
 

Jake.B

New member
Messages
495
Reaction score
0
Location
California-USA
Wow thanks i want to check that out i dont think there is much clutch hanging off i think i just a slight amount. If i welded the socket and pto together would that be the right way to fix it?
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
No, unless you took the crank out. How much of the keyway is in contact with the shafts keyway? If over 1/4" I would say you are fine. Just tighten it up very tight. I do not think the spacer would make much difference tbh.
 
Status
Not open for further replies.
Top