I need some help with issues with a replacement engine for an ongoing go-kart project.
Just purchased a Honda 5 hp off of craigslist ($20 and runs great) it was apparently from a power washer.
The problems are that the shaft size is 7/8” and extremely short (less than 2”) and the end hole is not threaded for a bolt to hold a clutch on.
How should I approach fitting a centrifugal clutch to it? (Preferably in the most cost effective way haha)
I have searched the net for about 3 hours trying to find some answers but have come up with little.
Any advice would be great!
(The only knowledge I have on fitting a clutch on is from the engine previously on the kart, which had a 3/4” shaft with a pretty standard looking clutch mated)
Update: I'm now leaning on replacing the crankshaft, preferably with a 3/4".. Need to know some information about the different 5HP models of Hondas and if the parts are interchangeable with the one I have.
Shaft
Only serial looking # I could find on it is '2HNXS 1611AK'
Just purchased a Honda 5 hp off of craigslist ($20 and runs great) it was apparently from a power washer.
The problems are that the shaft size is 7/8” and extremely short (less than 2”) and the end hole is not threaded for a bolt to hold a clutch on.
How should I approach fitting a centrifugal clutch to it? (Preferably in the most cost effective way haha)
I have searched the net for about 3 hours trying to find some answers but have come up with little.
Any advice would be great!
(The only knowledge I have on fitting a clutch on is from the engine previously on the kart, which had a 3/4” shaft with a pretty standard looking clutch mated)
Update: I'm now leaning on replacing the crankshaft, preferably with a 3/4".. Need to know some information about the different 5HP models of Hondas and if the parts are interchangeable with the one I have.
Shaft
Only serial looking # I could find on it is '2HNXS 1611AK'