Clutch/Engine Help

Status
Not open for further replies.

THill16

New member
Messages
3
Reaction score
0
I need some help with issues with a replacement engine for an ongoing go-kart project.

Just purchased a Honda 5 hp off of craigslist ($20 and runs great) it was apparently from a power washer.

The problems are that the shaft size is 7/8” and extremely short (less than 2”) and the end hole is not threaded for a bolt to hold a clutch on.

How should I approach fitting a centrifugal clutch to it? (Preferably in the most cost effective way haha)

I have searched the net for about 3 hours trying to find some answers but have come up with little.

Any advice would be great!

(The only knowledge I have on fitting a clutch on is from the engine previously on the kart, which had a 3/4” shaft with a pretty standard looking clutch mated)

Update: I'm now leaning on replacing the crankshaft, preferably with a 3/4".. Need to know some information about the different 5HP models of Hondas and if the parts are interchangeable with the one I have.

Shaft


Only serial looking # I could find on it is '2HNXS 1611AK'
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
ouchh. i dont know if its possible to get a 7/8 clutch (if they exist?) and tap the hole (lol) in the end of your shaft for a bolt.
 

THill16

New member
Messages
3
Reaction score
0
I have seen some 7/8" and 1" clutches on the web.. so they do exist but they are pricey .. For a 1" clutch to work I would have to use a bushing to get it fitting correctly..

But my main problem is that the shaft is so short that I am hesitant to even begin to look at ordering a clutch until I know one will fit.
 

THill16

New member
Messages
3
Reaction score
0
I need to know a little more about honda engines..

Are the parts pretty universal? I'm having trouble finding any matching engines listed under the serial number on mine. If I find a crankshaft for a different honda 5.0 hp model like the GC160 or GXV140 will it fit?

+ I have found some 3/4" crankshafts for the GC160 model. You think it would fit my vaguely identified honda 5.0 hp model?

Specifically looking at this part number : 13310-ZL8-600 which is a 3/4" shaft for the gc160
 
Status
Not open for further replies.
Top