clutch differences?

Status
Not open for further replies.

betoeclipse1

New member
Messages
44
Reaction score
0
Location
cartersville georgia
thats not the right crank. how did you decide what part number to order? if its a real honda engine, it will have honda on the case itself, somewhere. if not, its a clone, and which brand would be a guess. the new crank you buy/bought MUST look exactly the same as your original one, except that it would have the standard shaft end ,versus the "use specific" crank end that you have. that engine was designed to turn like small cement mixers and such,hence the 2:1 reduction box.
if you bought that crank at the advise of a salesman at a kart supply business, then he was a much clueless as a newb.......

Ok i will be returning this one and any idea where i can order one?
 

firemanjim

Just kartin' around....
Messages
5,247
Reaction score
88
Location
Houston Texas
Well, if we knew for a fact that it was a Honda engine, that would be easy to find. But , as previously stated , if its a clone, then you will have to figure out who the manufacturer/ brand it really is. All clones are identical to the Honda design, but you cant just swap any part for any make. There is always something different in design that vary's between brands. :eek:
 

betoeclipse1

New member
Messages
44
Reaction score
0
Location
cartersville georgia
Well, if we knew for a fact that it was a Honda engine, that would be easy to find. But , as previously stated , if its a clone, then you will have to figure out who the manufacturer/ brand it really is. All clones are identical to the Honda design, but you cant just swap any part for any make. There is always something different in design that vary's between brands. :eek:

It is a honda gx240 and not a clone but i just acquired a gx390 so going to hold on on ordering a new crank until i know for sure where i can get one .
 
Status
Not open for further replies.
Top