clutch and engine problems

Status
Not open for further replies.

CrazyFazy

New member
Messages
18
Reaction score
0
--------------------------------------------------------------------------------

Hi guys newbie here to the carting world. OK i am trying to get my sons cart running right but am running into some problems. The cart is a 5.5 HP honda engine with a centrifugal clutch. The original carb on the cart would run better if the choke was kept half closed leading me to believe there was a fuel restriction somewhere so i removed the carb and tried to clean it but the jets would not come out. After purchasing a new one i installed it and it kind of still does the same thing. Fuel restriction to the carb isnt an issue. It seems like there is a heck of a bog when you hit the gas even with the new carb. Another problem is that when my son sits on it and mashes the throttle it wont hardly move at all.Tore the clutch apart and cleaned it and still doesnt work. If i raise the rear tires off the ground or put the front end against something it will spin the tires but any weight on it at all will almost stop it completely. Could the centrifugal clutch be history? I havent counted the number of teeth yet on the sprockets but i will do so tomorrow as its 10 degrees here without the wind chill...lol. The guy who owned the cart before me raced it and was also wondering if the gearing was designed for speed instead of torque? The axle sprocket looks real big so wiouldnt that give me the torque to at least pull out? Thanks for any help anyone can provide on this.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Please do a search on the forum for gearing with a centrifugal clutch.
Words of russ- 'the rear sprocket should be up to 2" smaller in diameter than the rear tyre with a centrifugal clutch'.
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
Yup, either the clutch is bad, or your gearing is too high.Take the axle sprocket tooth count and divide it by the clutch tooth count. If you get an answer anywhere below 6, you are more than likely geared too high.

If you have a jackshaft, the gear calculation will be a bit different (clutch/JS in)*(JS out/axle sprocket). Divide the larger by the smaller. Like Brandon says, if your tyres are too large, you will also have a problem.
 
Status
Not open for further replies.
Top