jandj
Active member
To take the plastic "base" off (after removing the outer housing and the filter itself) there's two Phillips head screws and a bolt.
Attempting to remove the bolt -A 6 point 10mm socket wants to slip, 9mm's too small.
I have a set of those Snap-On "splined" sockets, but the 10mm one doesn't fit any tighter than the 6-point does..
The stock box can stay on for now, but eventually it's got to go.
I don't want to round off the bolt, any suggestions?
Attempting to remove the bolt -A 6 point 10mm socket wants to slip, 9mm's too small.
I have a set of those Snap-On "splined" sockets, but the 10mm one doesn't fit any tighter than the 6-point does..
The stock box can stay on for now, but eventually it's got to go.
I don't want to round off the bolt, any suggestions?