How many RPMs are you looking for????
Since you are looking for good idle, I assume you don't mean a 4000 RPM idle right?
I like the Black Mamba Jr because It works with my desired RPM range.
I wanted to keep the RPMs below 7000 to be safe with the stock flywheel.
It is considered a "Torquey" Cam.
Should be good to about 6500 RPMs depending on gearing, tire size, weight, .....
Pulls hard the whole RPM range.
I have the gx390 carb and a 30 series TC with stock springs.
It pulls hard from 2100 to 3100 RPM, then really gets going.
This might be the cam / carb or the TC shifting or a combo of both.
NRRacing or DynoCams are good places to look.
NR gives better descriptions.
They will tell you 6000+ or 8000 - 9000 RPM.
They will say for long tracks or short tracks.
They will say for 12:1 or greater CR or for 9:1 or less CR.
Most will want 32 degrees so you are good.
They will specify what springs will apply the appropriate pressure for the cam lobe shape.
For a yard kart, I'd look for something that says WIDE POWER Band. or WIDE Torque Curve.
---------- Post added at 10:15 PM ---------- Previous post was at 10:11 PM ----------
http://www.nrracing.com/category-s/2225.htm
---------- Post added at 10:28 PM ---------- Previous post was at 10:15 PM ----------
I'm wanting to get a new cam for my hemi. I'm looking for one that will give good performance and idle good. I have a Predator Hemi with no governor, billet rod and flywheel with 8 degree timing advance built in. I also have a big intake with a 22mm Mikuni carb. Has a header also. What would be a good cam for performance, good idle, needs 32 degree btdc timing? Also what springs would pair up with it? Thank you.
So a quick basic intro into Cams for small engines.
More lift = more power at any RPM
More Duration > shifts the Powerband towards higher RPMs
So a High Lift, short Duration cam might be a Low RPM, Torque Cam.
A Long Duration Cam may make it difficult to idle and run poorly until you get into the PowerBand of the Camshaft.