brazman007
New member
I just recently acquired a Thunder Karts XL700 go kart with a B&G 136202 engine on it that will not start.
I am new to small engine repair, so bear with me.
Here is what I know so far. I pulled the air filter off to expose the choke plate and sprayed brake cleaner in there and the engine started up in 1 pull and ran for just a moment while it burned off the brake cleaner. This tells me that I have a fuel supply issue.
I've removed the carburetor to see if it was clogged but I can't really tell. The engine sat for a couple years, so I know the gas is bad and needs to be dumped out, but I don't think I am getting fuel out of the tank because I did not smell gas when I removed the spark plug or air filter initially. I've also noticed that part 529A in diagram 2 below (it is a rubber grommet) has a tear in it. But I do not think that part is crucial to the engine starting.
Most of the gaskets are in pretty bad shape and dirty, but they don't appear to be in bad enough shape to prevent the vacuum being created to suck up the gas.
The diaphragm also looks kind of dirty, but not terrible.
My next thought is to remove the valve pin (173) to check to see if it looks clogged in there and maybe try to blow out the fuel line 611/612 with a compressor (these are part #s from diagram 1 below).
Any better recommendations on what to try next?
Links to part diagrams for the engine below for the carburetor group [1] and the cylinder group [2].
[1]
http://www.partstree.com/parts/?lc=briggs_and_stratton&mn=136202-0144-01&dn=07050008
[2]
http://www.partstree.com/parts/?lc=briggs_and_stratton&mn=136202-0144-01&dn=07050002
I am new to small engine repair, so bear with me.
Here is what I know so far. I pulled the air filter off to expose the choke plate and sprayed brake cleaner in there and the engine started up in 1 pull and ran for just a moment while it burned off the brake cleaner. This tells me that I have a fuel supply issue.
I've removed the carburetor to see if it was clogged but I can't really tell. The engine sat for a couple years, so I know the gas is bad and needs to be dumped out, but I don't think I am getting fuel out of the tank because I did not smell gas when I removed the spark plug or air filter initially. I've also noticed that part 529A in diagram 2 below (it is a rubber grommet) has a tear in it. But I do not think that part is crucial to the engine starting.
Most of the gaskets are in pretty bad shape and dirty, but they don't appear to be in bad enough shape to prevent the vacuum being created to suck up the gas.
The diaphragm also looks kind of dirty, but not terrible.
My next thought is to remove the valve pin (173) to check to see if it looks clogged in there and maybe try to blow out the fuel line 611/612 with a compressor (these are part #s from diagram 1 below).
Any better recommendations on what to try next?
Links to part diagrams for the engine below for the carburetor group [1] and the cylinder group [2].
[1]
http://www.partstree.com/parts/?lc=briggs_and_stratton&mn=136202-0144-01&dn=07050008
[2]
http://www.partstree.com/parts/?lc=briggs_and_stratton&mn=136202-0144-01&dn=07050002
usually due to cracked pickup tubes