NinjaFighter315
New member
- Messages
- 1
- Reaction score
- 0
My Briggs and Straton engine will not start. I was able to get it to run for a couple of strokes by putting some gasoline directly into the carb, but it doesn't seem to be drawing any fuel. I checked the spark plugs and everything else, and it seems to be in order. It seems that the problem is somewhere in the fuel system.
The carb on this model of engine is mounted to the gas tanks. There doesn't seem to be any type of feed hose visible on the outside, so it must be drawn from inside the tank. What are your opinions regarding replacing the entire tank/carb (The carb is very difficult to remove) versus just trying to repair whatever is causing the lack of fuel.
Here is a link to an album with some pictures. Any advice is greatly appreciated.
The carb on this model of engine is mounted to the gas tanks. There doesn't seem to be any type of feed hose visible on the outside, so it must be drawn from inside the tank. What are your opinions regarding replacing the entire tank/carb (The carb is very difficult to remove) versus just trying to repair whatever is causing the lack of fuel.
Here is a link to an album with some pictures. Any advice is greatly appreciated.