Briggs and Straton Won't Start

Status
Not open for further replies.

NinjaFighter315

New member
Messages
1
Reaction score
0
My Briggs and Straton engine will not start. I was able to get it to run for a couple of strokes by putting some gasoline directly into the carb, but it doesn't seem to be drawing any fuel. I checked the spark plugs and everything else, and it seems to be in order. It seems that the problem is somewhere in the fuel system.

The carb on this model of engine is mounted to the gas tanks. There doesn't seem to be any type of feed hose visible on the outside, so it must be drawn from inside the tank. What are your opinions regarding replacing the entire tank/carb (The carb is very difficult to remove) versus just trying to repair whatever is causing the lack of fuel.

Here is a link to an album with some pictures. Any advice is greatly appreciated.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Try boiling the carb in lemon juice or a concentrated citric acid solution after tearing it down to a level that you are comfortable with, then get a rebuild kit to replace seals and gaskets etc. Make sure your tank is clean and free of rust or corrosion. To remove rust, put some small nuts, bolts and or ball bearings in the tank with a bit of petrol or thinners. Shake the tank around until all loose rust has come off. Then drain the tank, leave it to dry and if you feel it is neccesary paint the inside with a suitable paint such as POR-15.

Then reinstall the carb to the tank using a new gasket. Put new petrol in the tank and try to start the engine. If the engine still does not start, make sure the gas cap is not creating a vacuum. Try starting the engine with the cap removed.
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
I had exactly the same problem with a very similar engine. Turns out it was the pump diaphram.

Unlike the honda & clone engines which, mostly, have a gravity fed fuel system, B & S engines have a pick up system which requires a small pump within the carby. This is usually located on the left side of the carb, looking from the back.

The pick up tube goes through the top of the tank. By removing the 3 screws connecting the carb to the tank, they can be separated to inspect the pick up tube
 
Status
Not open for further replies.
Top