I watched the video again and checked the comments.
He linked a Torque Converter that he used and said it was slow and built for a 10 year old.
Most comments I've read mention these being geared to low for good speed, but again... beyond my scope of knowledge.
I found this...
http://gokartguru.com/rider_lawn_mower_gearbox.php
Riding Lawn Mower Gear Box?
Question:
I have a vertical engine and a vertical transaxle. Can't I just use the transaxle on my go kart? It should be easier this way right?
Answer: Great question. Many people are asking the same question. "I have this old lawn tractor and it has this transaxle, can I use it?
Vertical Engine Problem
The problem with a vertical engine is routing the power from the engine to the horizontal wheels on the go kart.
Typically the standard method for transferring the power involves a gear box.
For example on a lawn tractor the gearbox is designed with a pulley on the top of the gear box (probably very similar to what you are asking about.)
Additionally, because the main purpose of a riding lawnmower is to cut grass, the vertical engine layout works very well for driving a mower deck too.
The temptation comes in to play to use the gear box in the gokart and keep the unit simple that way. Unfortunately, it is not really simpler, but more complex, not to mention unrealiable.
Transaxle Problems and Pitfalls
Additionally, I would strongly steer you away from using a riding lawnmower gearbox for the following reasons:
- Width of the rear axel system is too narrow.
The width of a gokart drive wheel layout should be relatively speaking wide: 36”+ for good stablility and anti-roll characteristics.
Riding lawnmowers are under that width, being naturally unstable and very prone to tippage.
Also the gear box will pose a difficulty in powering the rear wheels. Mounting the gearbox is another issue that requires special bracketry that would need to be fabricated and mounted to the framework.
-Gear boxes are not designed for high speed as in 20+ mph. This is a serious consideration, especially with gear boxes that do not require lubrication and do not have roller bearings. The gear box may end up siezing up.
-Gear Box Engagement requires belt tensioning devices. Typically, the gearbox is activated by tensioning the belt. To answer your question about internal clutches, most gear boxes are not that sophisticated, they just require the belt to be tensioned to engage the gear box.
Belt Tensioning systems also require careful thought (complexity) in their design so that the activation of the clutch can be deactivated when the rider is starting, or idling the go kart.
-Switching gears on the fly is not possible without good engine/gearbox knowledge. The gearbox on a riding lawnmower does not have synchronizers with it, so the gearbox must be completely idle or still for the gears to be switched.
Actually, in order to get gears to mesh properly, both the mating gears must be in the same position. This can be accomplished by running the gears at the same speed, but this does take some understanding of how a gear box operates.
Unskilled drivers will have extreme difficulty getting the gearbox to work. More than likely, the gear box will be destroyed in a relatively short period of time, if shifting is considered on the fly.
---------- Post added at 02:12 PM ---------- Previous post was at 02:03 PM ----------
And here are the results of the Advance Search for Threads with "Vertical Shaft" in title if you want to do some more research on your own.
http://www.diygokarts.com/vb/search.php?searchid=1991019