robbie
New member
Has anybody out there tried the new Predator 99 cc from Harbor Freight yet? I had a couple of their 79 cc engines (2.5 hp) and I loved them. I had those set up with approximately a 10 to 1 ratio using a jack shaft, and they had plenty of power.
I'm thinking of using the 99 cc on a mini bike with 11 inch tires and a ratio of 6.54 to 1. I could make this happen with an 11 tooth clutch and 72 tooth sprocket and #35 chain, although I'd like to see a smaller sprocket on the back. I could go for a 60T on the back for better clearance, but that would give me only a 5.45 to 1 ratio.
With 25% more displacement than the old HF 2.5 engine, this engine should handle a 6.54 ratio, I think. But I wouldn't expect it to handle anything less than that.
I dislike jack shafts enough that I would probably go for the bigger sprocket and put up with bad sprocket clearance. Any thoughts?
I'm thinking of using the 99 cc on a mini bike with 11 inch tires and a ratio of 6.54 to 1. I could make this happen with an 11 tooth clutch and 72 tooth sprocket and #35 chain, although I'd like to see a smaller sprocket on the back. I could go for a 60T on the back for better clearance, but that would give me only a 5.45 to 1 ratio.
With 25% more displacement than the old HF 2.5 engine, this engine should handle a 6.54 ratio, I think. But I wouldn't expect it to handle anything less than that.
I dislike jack shafts enough that I would probably go for the bigger sprocket and put up with bad sprocket clearance. Any thoughts?