An extreamly dumb question

Status
Not open for further replies.

e85

New member
Messages
150
Reaction score
1
Location
The great NW
sorry for so many posts but I am trying to become familiarized with coustom build gokarts. Any ways, what is a torque a verter or torque converter do? and when is it nesscary?
 

jpowers

New member
Messages
46
Reaction score
0
Location
philly
its a belt tentionar that gives you a ever changing gear ratio, and when ever you find it to be
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
the driver is a clutch that can turn the belt over the driven and give you variable speed. kind of like an automatic transmission. the driven is on a jackshaft and that chain goes back to your axle.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
To be a little more precise- A Torque Converter, TAV, etc is IMHO more properly referred to as a CVT. CVT stands for Continuously Variable Transmission. It is a belt driven power transmission that uses two variable pulleys to offer an infinitely variable drive ratio, withing it's range. For argument's sake, the range might be between 2.5:1 low, and 1:1 high. When the engine is at idle, the CVT is completely disengaged, allowing the engine continue to idle without moving the kart. As you increase the engine's RPM, the CVT begins to engage and the kart starts moving. As road speed increased, the reduction ratio begins to decrease allowing the kart to run faster. If the load starts to increase, like going up a hill, the ratio will drop allowing more torque to the wheels. The engine speed and road speeds affect the action of the pulleys. The short version of the story is that it's like having a completely automatic clutch and tranny in a neat little package.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
The pulley on the engine, or the driver has weights in it, so when the engine spins it the weights are pulled by centrifugal force and cause the pulleys sides (sheaves) to move towards each other. When this happens it tensions the belt and begins to pull the belt down into the driven.

The pulley on the jack shaft, or driven pulley, is spring loaded, so at idle it pulls the belt to the top of the pulley, but when the driven closes and pulls the belt, the springs allow the driven to open so the belt can go down further into the driven. The driven also has a cam on it, so if a load is applied to the torque converter ( the load could be, for example, climbing a hill) it makes the pulley close and pull the belt out of the driver.

When these two pulleys work to gather it causes the ratio to increase for high speed when there is less load on the engine, but allows the system to essentially shift down when more power is needed, and it does all this seamlessly, and automatically.

P.s. Slang for torque converter is "tc".



EDIT: darn! Toy story beat me, and I spent 9min typing that on an I pad! Oh well, the OP will really understand now! Lol
 
Status
Not open for further replies.
Top