Advice for kart drive train

Status
Not open for further replies.

mrpopo

New member
Messages
2
Reaction score
0
Hello, I am glad I found this forum and hope someone can lend me some advice. Right now I have put together an old kart for me and the kid to have some fun with (I think it is one that was sold at walmart about 10 years ago) . I have a 5hp flathead Briggs that I rebuilt stock except exhaust and air cleaner. In the future i will play around with squeezing some more power from it.

I am thinking about reworking the drive train now. The current system runs a belt from the clutch over to a pulley. A shaft connects the pulley to a small sprocket, and a chain runs to a large sprocket on the axle. It seems too overly complicated to me and a possible source for some loss of power but I guess it was made this way to mount the engine closer to the center of the frame. Is there any torque converter systems that anyone could recommend and could be bolted in place of the current belt? Would this be the way to go, or any other ideas to get a little more speed and fun out of this thing. This will be mainly off-road and I don't want to dump a ton of cash into it. Thanks for any advice!
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
If what you have is not a CVT, then it is a jackshaft. Setup sounds very much like it was used for compound gear reduction. Instead of a sprocket (chain) clutch, it utilizes a pulley (belt) clutch. Pics would be quite helpful, as would some gearing calculations.
 

mrpopo

New member
Messages
2
Reaction score
0
Here are some pics of the current setup the large pulley is about 5" and the large sprocket is about 10"
 

Attachments

  • IMG_20111213_155726 (Medium).jpg
    IMG_20111213_155726 (Medium).jpg
    109.1 KB · Views: 12
  • IMG_20111213_155655 (Medium).jpg
    IMG_20111213_155655 (Medium).jpg
    110.3 KB · Views: 13

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
You may be able to mount a comet 30 in that space. Measure the jackshaft diameter, and count the teeth on both sprockets. What is the rear tyre diameter, and the distance centre to centre between motor and jackshaft?

A comet 30 would be $100-150 w/o a backplate.
You could buy a maxtorque clutch, chain and jackshaft sprocket for $50. however the comet would be much better.
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
100% agree with r_chez_08... we switch these out over and over whenever possible its seriously cheaper for the clutch, chain, and sprocket than it is for the new belt drive clutch from Hillard.
 
Status
Not open for further replies.
Top