Hello, I am glad I found this forum and hope someone can lend me some advice. Right now I have put together an old kart for me and the kid to have some fun with (I think it is one that was sold at walmart about 10 years ago) . I have a 5hp flathead Briggs that I rebuilt stock except exhaust and air cleaner. In the future i will play around with squeezing some more power from it.
I am thinking about reworking the drive train now. The current system runs a belt from the clutch over to a pulley. A shaft connects the pulley to a small sprocket, and a chain runs to a large sprocket on the axle. It seems too overly complicated to me and a possible source for some loss of power but I guess it was made this way to mount the engine closer to the center of the frame. Is there any torque converter systems that anyone could recommend and could be bolted in place of the current belt? Would this be the way to go, or any other ideas to get a little more speed and fun out of this thing. This will be mainly off-road and I don't want to dump a ton of cash into it. Thanks for any advice!
I am thinking about reworking the drive train now. The current system runs a belt from the clutch over to a pulley. A shaft connects the pulley to a small sprocket, and a chain runs to a large sprocket on the axle. It seems too overly complicated to me and a possible source for some loss of power but I guess it was made this way to mount the engine closer to the center of the frame. Is there any torque converter systems that anyone could recommend and could be bolted in place of the current belt? Would this be the way to go, or any other ideas to get a little more speed and fun out of this thing. This will be mainly off-road and I don't want to dump a ton of cash into it. Thanks for any advice!