I'm looking for a clutch with a 7/8 bore. idealy it will have a pully on it but thats not that important as i could chop a sproket off a normal clutch and weld on a pully. Does anybody know if there is enough meat in the 3/4 bore maxtorque to bore it out to 7/8?
What is available in 7/8 bore? over here can only get the maxtorque in 5/8 and 3/4 with a sproket on it. Or can get realy expensive($300+) custom idustrial clutches and racing kart clutches which are also expensive.
to replace the engine pully on this so i can ride it without starting on a hill or having a friend push start me:
thanks
What is available in 7/8 bore? over here can only get the maxtorque in 5/8 and 3/4 with a sproket on it. Or can get realy expensive($300+) custom idustrial clutches and racing kart clutches which are also expensive.
to replace the engine pully on this so i can ride it without starting on a hill or having a friend push start me:
thanks
. You may want to check that though.