Magice
New member
- Messages
- 333
- Reaction score
- 0
So I rebuilt my 5hp briggs, new rings, etc.
The flywheel screen won't clear the shroud. I tried tightening the flywheel more, to a point where the bearings popped out (not smart). Anyway, I can the bearing holder to seal but it keeps wanting to pop out. The flywheel still won't clear. It does, but it scrapes the shroud a little bit!
Any ideas?
also non synthetic oil stinks.
The flywheel screen won't clear the shroud. I tried tightening the flywheel more, to a point where the bearings popped out (not smart). Anyway, I can the bearing holder to seal but it keeps wanting to pop out. The flywheel still won't clear. It does, but it scrapes the shroud a little bit!
Any ideas?
also non synthetic oil stinks.