4x110MM 1" Bore Hubs?

[Richard D]

Looking for hubs similar to this:

Zinc Plated 4 x 4 Wheel Hub (1" Bore) | AZ2289

www.bmikarts.com

But I need 110 MM bolt circle. Any ideas?

 

[ezcome-ezgo]

Very unlikely you'll find standard/metric mixed hardware. Adapt and overcome.

 

[Cindi_PDX]

110 mm is 4.33 inches, and adapter plate is easy to make.

I did find this on the gopowersports site:
5.5" Live Axle Hub
$27.95
SKU:KD110LA

10mm Studs
110mm Bolt Pattern
5 1/2" Dia Flange
2 3/4" Hub Length
1" Bore
1/4" Keyway

5.5" Live Axle Hub (KD110LA)

The 5.5" Live Axle Hub is a must-have component for any off-road vehicle, including go-karts and dune buggies. Made with high-quality and durable materials, this hub is designed to provide optimal performance and longevity. It's also compatible with a wide range of tire sizes, making it a...

www.gopowersports.com

 

[Richard D]

That's perfect! Thanks!

 

[madprofessor]

Cindipdx, that's a good find. I've tried to locate metric stuff for folks and mostly failed, I ain't British. Just now put that GPS page in my favorites column for the future.

 

[Richard D]

Those hubs were just what I needed. Had to enlarge the holes a tiny bit. I have the whole assembly mocked up in plywood. Need to tweak my CAD drawings a bit then get my parts cut by the waterjet.
last picture was an early mock-up in the frame

 

[redflash]

Is that the Miata diff ? I did the same thing, but I made a sheet metal CAN to contain the gears, then put 2 zirk fittings in the can and filled it with grease.

Da Flash

 

[Richard D]

Yes it is, and I plan to do the same thing, but I'll probably use aluminum pipe.

 

[Richard D]

What brakes did you use? Mine are the Polaris RZR, new discs and calipers for $45, can't beat that!

 

[Denny]

If it is a positraction it should be filled with the proper lube instead of grease. Does it have clutch plates in it?

 

[Richard D]

Not a posi. I’m on a real tight budget but I can always upgrade later if it smokes that foot wide sticky tire.

 

[redflash]

hadn't thought of the alum tube.....might alter....change is good right ?

 

[Denny]

I don’t think he is going to use aluminum tubing because it could not take the weight. It would fold like a cheap suit.

 

[redflash]

you're not supporting the carrier with the tube....you're just covering it to keep the crud out !


Da Flash

 

[Denny]

I thought you were talking axle. Sorry.

 

[Richard D]

Yes for the lube. Did you get the idea for the chain diff from the dude in England?

 

[Denny]

No I’ve known about it for years. The problem is where I live out in the sticks there ain’t any Myattos around for me to snag one. So I forgot about them. I hope you got the axles, hub bearings and control arms too. It would make your life a whole lot easier. Bonus points if you got the brake rotors and calipers also!

 

[Richard D]

I didn't get any of the other stuff. This will just be a simple rigid axle. No room under the 'glass shell for anything else. Just a bar hopper not a freeway flyer.