Brett066
Member
Can a 40 series driver be mounted inboard?? Or I guess a driven modified to run with the spring side outboard??? Otherwise, it looks like a new motor mount is in order because my alignment is waaaayyyy off. Thanks in advance guys!
40 series driver mounting
- Thread starter Brett066
- Start date
- Status
Yes it can. You must need the correct spring.
Wait...... You said driver?? Not to sure about that. The driven can be
Wait...... You said driver?? Not to sure about that. The driven can be
Brett066
Member
Yes, thank you!!! I kept researching after i posted. I am just goin to have to order a spring..... I was just hoping maybe the driver would be flippable to save $. Oh well.
driven[jackshaft] MUST be mounted inboard (unless you change the spring to the yellow reverse wound) then it can be mounted outboard as well
(I say it must[should] float,
Grant disagrees with me...
I have not even touched a series 40 in my life, he runs several [all inboard afaik])
the driver[engine] however must run outboard and it must not float.
'sid
(I say it must[should] float,
Grant disagrees with me...
I have not even touched a series 40 in my life, he runs several [all inboard afaik])
the driver[engine] however must run outboard and it must not float.
'sid
- Status