250 ninja

Status
Not open for further replies.

travis

New member
Messages
3
Reaction score
0
hi guys brand new here frist post !! need lots of help i can get a 250 ninja that has no compression on one side and 70 on the other is this worth messing with if so can i put it in a go kart if so how hard are these bulids thanks guys
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
cool, welcome to the forums.

youre saying the engine is free? well absolutely 0 PSI on one side might mean the piston has a hole or a connecting rod broke. rarely does a blown head gasket or rings mean no pressure at all.

as for how hard it is to build.... there is no set "hardness" (thats what she said) but what are you imagining? on road or off road? front suspension, full suspension, or no suspension? do you have a welder? what tools do you have? are you planning full roll cage or just a flat kart frame?

drawing a picture helps.

good luck.
 

travis

New member
Messages
3
Reaction score
0
yes its free ! i am not sure on the kart yet yes i have two welders my gf has a 6.5 hr go kart already that is kinda a off road one that i might be able to use but i really like the shifter type karts they look really fun so do u think the 250 is worth fixing ??? thanks for the input
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
or, even if you cant fix it for cheap enough, what is there to loose?

you could sell parts from it if you decide to not use it and make $ for a new engine...
 

Rustydog2010

NZ Nutta :|
Messages
945
Reaction score
2
Location
New Zealand
I would grab it. Parts are easy to come by. (Here at least.) Possible situations for low compression are; no piston or rings, worn rings, hole in the piston or in the block, blown head gasket or malfunctioning compression release. (If it has one.)

All of those are pretty easy to fix, except for a hole in the block.

If possible try get the carb and electrics with it, will make setting it up easier in the long run.

Welcome and good luck.

Jeremy.
 

travis

New member
Messages
3
Reaction score
0
the guy at the shop said that they are leaking between each other ??? is that maybe a hole in the block ? as far as my skillls i have torn a few car engines a part i can weld just find never really bulid anything like this but with yalls help think i can get it done do yall think i should try useing the go kart frame that we have here with the 6.5 and jsut beef it up a little ??
 
Status
Not open for further replies.
Top