element10554
New member
how bad is it exactly? surface rust, or is it serious?
Surface rust
how bad is it exactly? surface rust, or is it serious?
what? can you draw that? lol, or post a pic of it? im confused.
Your old wiring is a mess and I can see how it would make this all seem much more complicated than it really is. For now, dont try to make sense of how the old wiring was connected and just get an understanding of what these 2 switches need to accomplish.
Your stop button just needs either one of its 2 wire terminals wired to a ground source. (any metal part of your engine or kart frame would be just fine) The stop buttons other terminal just needs to connect to that single wire you found exiting from the inside of your engine. (that wire is coming from your engines Magneto) The engine will run fine with out this wire even being hooked up, but if your stop switch sends a ground signal to this wire, It'll simply function as your kill switch to shut the engine off.
Ok your starter solenoid has 3 connections:
One for the battery cable going to the positive battery post,
Another one for the battery cable going to the starter,
And finally that small push-on spade connector that simply needs to connect to either terminal of your start button.
The start Buttons other terminal just needs to be wired to either end of your battery's positive battery cable.
Your starter solenoids mounting bracket needs to be grounded for the solenoid to work. This is usually accomplished by mounting the solenoid to the engine or go karts frame.
And the last thing is your battery's negative battery cable should be attached to a metal part of the engine somewhere.
So to sum it all up:
The stop button simply needs to send ground the engines Magneto wire to act as your kill switch.
And the Start button needs to send power to the solenoids push-on terminal to make your starter crank the engine over.
You could probably re-use some of that old wiring if you want. I know wiring can seem complicated at first, so let us know if you dont understand any of these instructions![]()
Reffering to my diagram the red wire from the starter button has to link to the red wire coming off the postive side of the starter solinoid?
Yes, and using that in-line fuse in this wire is a good idea
Then the white wire also coming from the starter button has to link to the tab that is on the starter solenoid?
Yes
Then for the stop button the green wire mounts onto the top of the engine in one of those two spots. So the black wire with the tab adapter links to?
The black wire needs to be attached/grounded to any metal part of the engine or kart frame. The green wire needs to be connected to the magneto wire you found under the dead leaves in your video.
Forgive me for not re-reading everything- been awhile- Is that an 18hp Briggs Vanguard V-twin? If it is, gimme a bit and I will go check mine...
Dismantle and clean the carb.