$100 Manco Dingo

[STiForester]

I used 1/2" washers and bored them on my lathe to 5/8 or about .635" to accommodate for any nicks or gunk. Anyways one washer on either side and it worked. Also I had to move the sprocket over about half inch towards the engine because the previous owner moved it to run a centrifugal clutch

 

[STiForester]

Next will be to weld a tab on and wore up the kill switch.

 

[Sinbad001]

Manco steering wheels usually have a hole for the kill switch.

 

[STiForester]

I know I had mine there. It didn't last a day before the site got ripped out riding like mad men in the snow

I'd like to run a fuel cell under the steering between my legs and a different carb. Are they all gravity fed or what's the options here?

 

[Camaro71]

Hey I have a dingo as well , im not sure if yours is a briggs ,but I'm having some problems figuring out where the spring from the governer arm hooks to the gas cable linkage , and was wondering if so maybe to have a picture for reference, thanks . -Terry

 

[STiForester]

Yes I have a Briggs and I can take some in A bit

 

[Camaro71]

Thanks so much , when you get free time ,would be greatly appreciated .

 

[STiForester]

I'll take some pics today I forgot over the weekend!