Search results

I agree. I guess I will stamp a number on it so it can be identified if it goes missing. It would have been nice if they at least put a model number I spent awhile looking at different model numbers to find a Manual for it and I am not sure if I have the right one Thanks

I have a Carter trail buster and was wondering if the is any serial no. or model number stamp any where on the kart. I looked all the normal places. There is a label missing by the seat that I notice but see any other marking expect the trail buster name on the floor. Thanks

Hello from the middle of no where. I have built a few karts in the past and still have one that runs , 1 that needs to be finished and a new basket case Carter trail buster I pickup last week. I have the Carter almost going just waiting on tc parts. First kart i built in the 60's was out of wood...

I was wondering I was under the impression the driver with the nut out from the motor then the driven had to have the spring on the engine side. This is so the belt will ride straight up and not be pushed out of alignment?

Does anyone know if the 203785c ( 40_85df ) belt is the same as the 203785a belt? The a belt says 33.87 oc and the c belt is about 34.5 inchs

Thank you Sid for the help. I ordered the bushings and spring.. now to fix the hacks the old owner did to the rest of the kart. Once again thanks

Because the 2 on the post are worn. They are held in place with a split ring in a groove and the belt rides on them when idling and 2 for the spring. ---------- Post added at 08:05 AM ---------- Previous post was at 07:56 AM ---------- Or should the shaft be bare under the belt.

Thanks Sid. I will order 4 bushings and a spring later this week. Do you know if the 3/4 adapter is welded or press fitted in or just rusted solid. I can't find any weld indications. The post is 1/4 keyed outside 3/16 inside for motor shaft

Thanks. Yes it is a 40 it has the welded nut on the driver and the 3 weights 3 springs. It is on a cater kart. I figure it's from early 2000 -2005 or some where in that area. It has a 3/4 inch adapter in the 1 inch post plate that either was installed by Carter factory or someone else. The...

I need help on this clutch. It is on a Carter trail buster. I bought it yesterday. The driver is different from all pictures I have seen. First is it has 2 brass rollers under the belt on the fixed face post are they the same as the bushings as in the moveable face? Second question is the spring...

Turn the clutch on the motor around that will solve your problem. The moving plates work opposite of each other to keep belt centered.