Search results

I finally got the hub off. Thank you for the help. Heat was the trick.

Any idea where i can buy a hub like that? Just i case i ruin mine trying to get it off.

The hub and the shaft (axle) have to be separate parts don't they? If not, how would i ever get the sprocket off and replace the brake. That pic does look like the hub that i have.

How hot or how long do i need to heat the hub up for? Do i heat the entire hub or a certain part of it?

I've attached some photos of the hub. I've tried all the suggestions and I still can't get it to budge. The only thing i haven't used yet is heat.

Thank you to everyone for the suggestions. i will try these tonight and will also post some pictures.

I looked at the hub all over and i didn't see a set screw anywhere on it. The flange of the hub is starting to bend when i tighten down the puller.

Where are the set screws on the hub?

The hub is what i cannot get off the axle. It has a keyway, but will not slide off.

I am having trouble removing the sprocket from my go kart. I need to remove the sprocket to replace the brake. I took off the wheel and there is a piece that is infront of the sprocket. I tried using a puller to pull that off, but it won't budge. is there something i am missing?

I found it. I really didn't see any pics of how to correctly hook up my throttle and the springs.

I don't see that link in the FAQ section.

Yes, tight as in hard to turn to the left or right. I will post some pictures tonight after work. Thank you for your responses.

Can someone post some pictures of how to hook up the throttle cable to to a Tecsumeh Power Sport engine? I have a few springs and the throttle cable and i can't figure out exactly where they all hook up. Thank you

I just purchased a used 2 seater go kart. The steering is very tight. What are the steps i should follow to help with this issue. Thank you