Search results

What size teeth on the clutch / wheel should I use? For right in the middle of torque/top speed? The wheel sizes in the rear are 6" and the front being 4".

After every mild use of the motor, it begins to run rough. I have to clean the plug after every use. Should a simple cleaning of the piston head fix this? It's dirty from what I can see from the spark plug hole. The only reason I haven't done it already, is i'm not exactly sure how. Do I simply...

It's the meshed wiring. It seems it may cut off to much airflow, as the engine struggles when idling when the filter is attached, removing it, it runs fine. Should I just stick with the stock B&S airfilter replacement? Or is there something I can do to get alittle more air flowing in this thing.

It's 3/4.

Assuming I have 4 x 4in tires, the size says: 4.10 - 3.50 - 4 I want to replace the rear tires to 6in just to give it alittle lean. Does this put extra stress on the motor? It's a small 3HP, what size teeth should I use on the hub and the clutch, as I'm looking to replace both. Thanks

How do I measure the shaft? I just took the clutch off, which was very wobbly (it had multiple washers in front, which doesn't seem safe)

Hello! First post. Sorry for the many questions. I recently found an old briggs motor (3HP, flat top?) that someone had thrown away, and amazingly enough it runs. But it's completely missing the air filter, along with a muffler. I just bought a straight pipe for now. I'm new to small motors...