Search results

I repairing a Kasea LM150llR. The brakes didn’t work. The pistons on the front were frozen but I got them loose. I replaced the back caliper. I’m not sure if what is considered normal. The brakes seem very weak. What is the normal feel? I’ve never driven it new so I have no idea what normal...

Carb replaced with a new one. Seems it may be set too lean. Has anyone else had this problem. Having trouble getting restarted after initial startup. I’m guessing the auto choke cuts off when warm and it’s not rich enough to restart.

I’ve let out the cable at the handle and at the brake but cannot get it tight enough to hold the kart in place. Is there an adjustment I’m missing?

Front brakes on this Kasea seems to have rusted and locked up. I pulled them apart and found rust on the piston. I had to pull them out with pliers. Too me a few minutes to get them to even turn. Not sure if it’s worth trying to buff them up and put them back. Any suggestions?

The seat belt buckle will no longer release the tongue. It’s been outside. Is there any way to replace the buckle?

I got into the steering gear from the top access and discovered the grease is like thick glue. It’s almost solid. Turns only with great effort. Any suggestions for repair other than replacement.

Oy vey. I knew it had been parked outside but I didn’t expect this. Anyone have any suggestions? I figure I’ll change the oil with something cheap and run it a little and then change it to some good stuff. Anyone have this issue before?

I have a Kasea LM150 ll R and need to replace the master cylinder. The part number I have is 6.000.027 but it shows a two pin master cylinder. Will the two pin master cylinder fit in the frame? If so can I replace the single pin spindle with a dual pin spindle? Seems I would have to but I...

The headrests in the bench seat sit into the frame of the seat. Rust has caused the area around the plastic inserts to swell. Does anyone know where I can find replacements for these plastic inserts? I have to reupholster the seats and replacements would make this easier.

https://www.ajusa.parts/image/catalog/kasea-lm150-03/kasea-LM150IIR-17.png Number 12 steering gear. That device has what looks like a large plug on top. Does that hold grease?

The bench seat on the kasea go kart is pretty much rotten. I could use it as a template and build a new one but the material may cost more than a new one. Seems a seat for that model may not be available. I tried AJ parts to no avail. Does anyone know of a parts house that might have one? The...

I’m working on a kasea go kart with the GY6 engine. I had to replace the resistor due to the tabs rusting away. I replaced the plug. It was stored outside. I checked the spark but it will only spark once or twice but that’s it. Seems to spark just as it’s starts to turn over and as the switch...

A friend brought a Kasea go kart to repair but I don’t know much about it. The vin is lagbtrfu335-000596. Any help would be useful.