Search results

Shown on Harbor Freight Engine. The KIT purchased from AGK worked...but as posted in Dec 2009...."The kit "throttle lever arm" was about 3/16" too long...I had to shorten it and now the "butterfly" closes as should and actually allows the idle screw to do its job." It came too long and by not...

I have a toggle already built in under my steering wheel and I want to install a kill switch. Someone mentioned that I can install it to the on-off switch but I don't know if I should splice into top or bottom wire. I was told that one would give A BIG shock so would like to "pick" the right...

I have everything set on my gocart but the engine runs full throttle when I slide the choke to the right. I can not get the engine to idle at a reasonable speed when I slide choke all the way right. Is the engine supposed to idle when the choke is slid all the way to the right? or are you...

RE: blue honda clone finally mounted Hi...I am almost ready to start and try out gocart...but can not figure out how to tighten the bolt/lockwasher/flat washer that fits in the end of the crankshaft and holds the clutch in place. How do I stop the crankshaft from spinning when I try to tighten?

I have a 4-1/2" beat up drum that has (4) 3/8" dia. holes on what I measure to be a 3-1/8" circle. looking for new drum and band Is this correct size? I can not find that item/dimensions online... ____________________________________________________ first timer fixing old frame and mounting...

Hi! I picked up a used frame for my kids for Christmas, a 6.5 Greyhound engine fromHarbor Freight, and clutch-new brake-cable-chain from Northern Tools. Will be trying to put together the week after Christmas day and I am not sure if will have running or not...but truly hoping can get it done...