Recent content by whait86

i would suggest 2-3 more lateral cross members, but other then that pretty much good to go for pavement.

no clue, i work for the man, so whatever is standard goverment antivirus software.

^--epic

ive seen some homemade paintball guns that shoot bigger then .68 but the air consumption is horrible, the guys had to carry big *** tanks on their backs just to stay out on the field for a whole match,and more often then not they had breakage in the barrel, but they were badass. the shotgun...

that site is blocked on our computers stating that it uses malicious code or somthing.

get a thicker gasket?

why did i just picture a giant blower on the top of a go kart engine..

ive tired it on lawnmowers and it worked for a few weeks then i went and bought a gasket, i coulndt imagine it holding up under load, use regular gasket imo.

look for a tippman 98, (about 30used to 110 new) they are the most reliable marker for the money, but when your looking at paintball stuff consider a face mask, air bottle(always buy new unless you know who your getting it from) paintballs(most expensive part), to start. its not a terribly...

ive taken one apart by compressing the shock, using a spring clamp to hold the spring down and then extending the shaft out to max turning the inner shock a 1/4 clockwise then puling it out about a half inch then rotating the shaft again counter clockwise and then removing it completly.

i thought i might do the full suspension due to the fact that my son loves driving off theses little berms in the field, just using the tires to absorb the impact might be hard on the frame/kid ( its about a 18-22in drop) his power wheel can do it, but when i did it i thought i broke my butt.

the green arrows point to cv shaft/axle/sprocket from right to left http://i1063.photobucket.com/albums/t507/whait86/rearend-1.jpg

thanks so much, man this site is awsome, absorbing so much information..

to do and independent chain drive system youll at least have to get a couple cv shafts to hook up to hubs, it should be nominally easy to devise a way to link the other ends to the drive off the sprocket

i play a crap load of woodsball. lots of fun.