Recent content by tramont

Almost Done Ordered my comet torque converter for 119 and i think i might need a jackshaft any suggestions

Almost Done you guys

oh okay thx

Here is a couple of pics and my current setup. http://www.youtube.com/watch?v=JaFVr_1Uq2M Also any idea on how to setup up this toggle switch to the engine. The middle prong says accessory.

i have it now im going to make a video tommorow of my setup

NVM I made a creation for the throttle arm so i can use my existing throttle linkage im going to post pics later

Ohhhh.....Could i still use my current throttle linkage and just attach a spring or something to the carb

It still is happening and here is my setup http://www.youtube.com/watch?v=A35HXWqPVMU

also how would i cut the arm?

Thanks you guys. Im kinda a newbie at karting. This is my first kart.

Yea its was working fine before i did that. Also i don't have a throttle linkage because i havent hooked it up to my go kart yet but i still have the stock throttle stuff hooked up

Since i removed the governor the 212cc predator engine idles wide open. also i don't have a throttle linkage yet if that matters. Was it okay that i left the internal governor arm intact? What happened was it had got kinda bent by the crankshaft so i just push it over out the way and it doesnt...

when i removed the governor today i turned it on now it idles wide open even when its on turtle. I have a 6.5 predator engine. No throttle linkage yet. Also i left the internal arm in because the way i have it its not able to move so it wont bother the crankshaft. and also i left the governor...

I found this deal on a torque converter for anybody who needs it http://www.ebay.com/itm/Comet-30-series-torque-converter-replacement-kit-kd30tqkit-/330757348332#ht_943wt_1139

I painted it today ima put up pictures