Recent content by slrichey

I need: 11802 Hex Axle 1557H Hex axle flange x2 Or any ideas on how to figure something else out that will work in their places. Thanks!

No one???

Sorry to ask, but I have searched the archives here and cant find it. I am in the process of putting a Manco 710E kart back together. It has a Subaru EX27 robin engine. I have everything in working order except the linkage from the throttle to the governor and top of the carb. I cant for the...

wont the spring loaded part of the clutch come apart when i remove the nut? Is there a trick?

if the old key sheared, how can i just press in a new one?

I am working on a Manco 710E. I put a new belt on today. The bottom drive part in the diagram marked #1 spins freely on the shaft. I am assuming this is just a broken key... parts list shows 3/16" x 2" long, #2 on the diagram. Is there anything I need to be aware of before tearing into this...

going to pull the pulleys off the subaru engine in the morning. It looks like a 1" shaft but hard to tell. with all the "stuff in the way"

Thanks. I was more worried about shaft size and making the belt work. I can fabricate a mounting plate if need be. Link to engine. http://www.harborfreight.com/predator-346cc-ohv-horizontal-shaft-gas-engine-certified-for-california-68136.html

I did. They told me they just sell the complete carb for $130ish I looked at a 11hp predator at harbor freight. I can pick it up for around $250. Anyone know if it is a direct bolt on fit?

I recently acquired a Manco Fox 710E for a steal. Going through it, i have found the carb float bowl is missing. I have searched for days online and cannot find just the bowl and screws. Any ideas???