Recent content by questseeker

guy s in this club do not like my idea of two strokes the one guy reved out my motor for 3min had to push away all i want to know if i went too 60tooth off driven is that compatible to this motor with a 13 tooth gear off the motor max rpm is going to be 8000 hey toy story where is this diygk...

was not my intent have rivals in this garage do not believe in two stroke power motor. survived even fellow carters are on this want to discouraged 2 stroke power but if went too 60 tooth driven on centrifugal 13 could i show these guy carts handle much better with bigger driven gear i want...

friend of mine says great butt not stable he was wrecked in early motor altercation can no longer ride i would never ride one of these just because of instability

also 1'' shaft out of motor but turned down 5/8 end shaft plan to build up rest of shaft so i have 2 1/ 2'' took 5 hrs to mount this engine it was out of a snow thrower

fowler you were talking engagment speed this thing idle speed 2000 have had it rev out full speed did not self destruct for 3 miutes would say min would be 10000 had to shut down only because was vibrating off stand sugestions

well its running still have rpm issues can i put a tach on this toy story said that 4 " 1 would not work what will also am still good with centrifagul clutch i am looking at geting a 60 tooth drive same tires does this 2stroke ever wind out

what are you building what application what are you driving dn

will there be any difference with or with out governor on this motor and if there is any benefit to a cvt over centrifugal clutch

so is it safer to put the gov back indo you think

i agree go with the tubing and extra bends will make for a better cart handling and roll over this will take more time but well worth the effort if you want i can send you some piscs of our carts from how we bought them too what we have done to themspace fram is the way to go

how do i figure rpm for 138 cc two stroke i am planing on no governor running 13 drive centrifugal clutch secondary54 drive tires are 13 in and what would be max speed with this set up

hey is that a tecum 139 cc have one turning shaft down would like to know what speeds drive gear 13 teeth secondary 54 teeth tires 13 in is this good combo for hole shot

sorry wrong post

hey that tecum engine is it 139 cc have one have to turn shaft down and make longer any idea what the rpm on this would be using on cart 100 lbs no govenor 40 pitch chain drive engine 13 drive secondary 54 tires 13 in

if i would go to 16 in would i get a better hole shot with a tvc