Recent content by Mr.Pedroza

Hey guys I recently had my father beat up on a wheel that he thought was steel. We were trying to get it off the kart but I forgot to mention it was Aluminum. Is this a fixable thing or do I need to buy a new wheel? I posted a youtube video and the wheel is shown at 6 minutes. He is the video...

I’ve rebuilt the whole thing and yes with auto choke off too

Hey y’all so I’ve rebuilt my Carburetor after a year of sitting outside plugged with rags on the kart but I keep trying to run it but eventually after 5 minutes of idle the Carburetor keeps over flowing and spits and sputter and dies any thoughts? Or do I need to provide more info

Yes I have I installed a hydraulic disk brake for a yerf dog 3203 it made a work of difference but I did have to buy a new axle to remove the other brake hub it was rusted solid and so were the wheels so check if the axle is rusted and the other components are movable to see what you're getting...

Does any one have any tips for a restoration I've check the compression and made the big leap of buying the carburetor so in my book there is no going back

Another one

How much is this worth and what is it ?

The chain is skipping so either the chain is out of line or the sprocket center isn't perfectly center or the chain may be too loose or tight

So I'm guessing there's no other advice other than to buy a new system ???

I've even subscribed to go powerssports on YouTube

Yes I did but I don't have the money for the full torque converter set up from go power sports

That actually won't work that plate is used for the yerfdog models with 5 hp Tecumseh engine or 212cc predator I have a equivalent of a 420cc predator which has a different bolt pattern that the smaller engines which fit that plate

Yes I know I've seen the belt charts and I'm still holding out on buying more belts until I know exactly where I'm mounting the driven unit so I can buy the right belt

I actually don't have a back plate for my torque converter I asked Gopowersports about one and they don't seem to sell it separately ... I understand they make their money that way but anyways I have the drive and driven unit with a 3/4 in jack shaft I'm not sure if I could buy pillow blocks or...

Hey guys I've ran into a big problem in finding a way to mount my 40 series TC on my yerfdog spider box with a 16 hp lifan engine i've just been looking for some advice on ways to mount the TC. In lou of pictures here is a video to get all angles of the engine and swingarm...