Recent content by mo841

If you have to pick between a bench grinder or angle grinder, go with the angle grinder. You can debur, wire wheel, cutting wheel, and grind away with an angle grinder. Sharpening drills isnt that hard to do on a bench grinder although I prefer a belt sander. Grinding a drill on a angle grinder...

If you want to sharpen drills its much easyer to use a bench belt sander than it is a bench grinder. I resharpen drills all the time at work because my drills are pretty expensive and its convenient. There is probably a million videos on you tube on how to do it. With a lil bit of practice you...

Just remember, the bigger the drill bit, the slower you want it to spin. Use some type of cutting oil or coolant also, that will make the bit last alot longer. 1/2 holes and up you wanna spin the bit to where the flutes can barely be seen individually (500 rpm and slower). Obviously the more...

This is the box I use everyday at work as a manual machinist. All of my car tools at home are not in a box so this is my only one.

Im pretty sure they are made in mexico. For what they are, they are pretty decent. Im building a rear swing arm for mine. The bumps get hard after a while

It is pretty heavy for less chatter but it is very well balanced. the rod in the middle is offset a tad. I only use it occasionally for wide plates and run about 800 rpm so it don't beat up the machine to bad. My shop actually just had my head rebuilt so the bearings should last a lil while...

first two pictures is a Fly cutter I made that will cut around 7 1/2'. the last picture is a bit I made so I can use a drill to run my table up and down

so I started my other non modified warror at my dads today and found that the rabbit and turtle sticker is actually wrong for how they should run. I messed with my linkage a little more today and now it will idle without taking off, seems that the therotle was not sitting home all the way.(was...

ok so the first image shouldbe when my therotle is sitting in the closed position. the second should be when I have it wide open. I painted the link orange. There is no binding or anything. I checked the lash and it is good. so I guess the problem is in the carb some how. thanks for any help!

so I removed the governor on my baja warrior mini bike and now it doesn't run very well. when I run it with the choke in the turtle position it wants to take off without me hitting the gas. I have to kill the bike to get it to stop. when I run it with the choke in the rabbit position I cant even...