Recent content by kroncaddycustoms

google shows absolutly nothing for a wiring diagram, thanks for the try, i been looking for 3 days on google and yahoo no luck

ok awsome thanks, i opened the starter everything is good ,nothings melted but the solinoid off the starter is gone, spark plug is fine except no spark plug wire, must have melted, i can see all the colors on the wires and need a wiring diagram to figure out what goes to what, anyone have any...

hey guys, i purchased a 200cc gio engine for $10, catch is the bike caught on fire and melted the wiring(only to where it goes inside casing,) the gears still works and none of the gaskets have been damaged the plastic drip on it and made it look worse, is there anyway to tell if the engine is...

i had a 200cc gio with gears given to me , the catch is his atv caught on fire, melted the plastics ect, how can i tell if the motor is still good? no castings or the head or nothing has been melted, oil still looks good, motor just looks dirty from soot and plastics, also i am not going to need...

i found a gs550 bike engine for under $200 runs great, if i was to put this in my buggy what electrical do i need off the bike to go with the engine to make sure it runs,? is this a decent engine that will provide good power?

ok thanks i will definitly check into the comet series, with that style i would have to put a jackshaft in aswell correct? i need to know what size sprocket for jackshaft and axle sprocket, it currently has 37 tooth, i built the whole chassis from round tube and front and back of 110cc atv

so i basically have a rolling chasis now, i have a new gx340 337cc honda motor 11hp, i tried a centrifugal clutch (sprocket style) straight from motor to axle, burnt it out within 5 mins from the lack of gear ratio, what kind of clutch should i be looking into , i strictly want torque , would be...

ok i will get some pics asap, and sorry for the constant posting just very frustrated in getting this kart to move correctly, if i get some pics maybe you can help me walk threw this and figure out the proper setup, much appreciated mike

hey i have currently just built a mini trophy truck i am new to karting. it seems to be a pain to put my 11hp honda engine on it.i have to buy a torque convertor setup with jackshaft and change sprockets,if i was to put a snowmobile engine in it, could i use the clutch to rear drive with out a...

i need torque whats the best setup for clutch 1 inch shaft

do you think this engine will produce enough torque or power, how big of sprocket 60 tooth? its 6 feet long and with engine on back swing arm with shocks weighs less then 175 pounds lol

hey i currently am new to go karting ect anyways me and my buddy built a full cage mini trophy truck and is almost complete i have a 11 hp honda gx340 off a pressure washer, i put a centrifugal clutch from princess auto and burnt it out with in 5 mins had no pull at all to it, the rear end is...