Recent content by kingquad2009

If I take a pic of my crankshaft end can you tell me if it will work?

Where can I get those?comp cams seemed t have a good deal on them.Whats the best way th remove the starter cluch and flywheel?My small engine book shows a special tool similar to a 4x4 hub socket but thi tool is hard to find.

I will take them,but if I go this route I am going to buy a billet con rod and remove the governor.Would that work?I get paid next week,so pm me your address and I will let you know when I send out the money.:wai:

What do you want for it? What would it be to ship it to northern Arkansas,zip 72642?

I need my carb on my 8hp,otherwise I would.

Sorry for dragging this post on,but how many cc's is the 8hp?I have heard 319cc and 400cc.Thanks:o

How much hp can a max torque clutch andle compared to the cvt?Do you know offhand where I can get one for a 1'' crank?

I am in need of a clutch for the 5hp, 1'' crank,but the only ones that I have found to fit it are only rated for 7hp,and I may build up my engine sometime.The cvts are nice but I would have to mod my frame to fit one.We had a 5hp kart in Pa that had a centrifugal clutch and that was kinda what I...

So how easy is it to over-speed these engines without the governor while under a load? I imagine some trouble would exist if the engine was suddenly subjected to a no-load situation while under throttle like a chain break or something. :stir:

Will the 8hp B&S blow up at 5000rpm like the 5hp,and if so is there any performance parts for it to allow for governor removal?Sorry for all the questions,Im a newb!:wai:

Really? Wouldnt it need bearings and new seals too?What about the flywheel fitting,or is it just 3/4in on the one side where the clutch goes on?

It does have a 1" crankshaft.It has been sitting in a friends barn for awhile.My options for clutches are kinda limited for a 1" crank are they not? I have a 5hp briggs on the kart I am building and it has a 1" crank and the most I could find was cvts and the HD clutches.Take a look at what I am...

they sure taste good but dont think they would deliver much boost!:roflol:

I cant find any numbers other than 52 on the flywheel.It had a sticker that stated the model and all the info but it is messed up beyond recognition :mad2: here are some more pics.Solomon-where did you get your parts for yours?I think this is a 190000 series engine of some sort.

Thanks for thr replies,I will check numbers today and will let you know.:cheers2: